Toro Greensmaster Flex 04853 Operator's Manual page 10

Note:
The distance between the bottom of the
screw head and the face of bar is the height of
cut.
Figure 13
1. Gauge bar
2. Height-adjusting screw
2. Tighten the nut.
g000489
3. Nut
Adjusting the Height of Cut
This cutting unit comes standard with the Edgemax
Micro-cut bedknife and standard bedbar. The
effective height of cut depends on previous mower
configurations and turf conditions (i.e., roller type,
bedknife behind center distance, soft or firm greens,
season conditions). Set the initial height of cut 0.25
mm to 0.38 mm (0.010 to 0.015 inch) higher than the
previous greensmower setup and adjust it to match
conditions.
Note:
For heights of cut greater than 13 mm (0.500
inch), install the high-height-of-cut kit.
Refer to Setting the Cutting Unit to Match Turf
Conditions (page 8)
best suited for the desired height of cut.
1. Loosen the locknuts securing the height-of-cut
arms to the cutting-unit side plates
1. Adjusting screw
2. Flange locknut
2. Hook the screw head of the height-of-cut gauge
bar onto the right side of the cutting edge of the
bedknife and rest the rear end of the bar onto
the rear roller
10
to determine which bedknife is
(Figure
Figure 14
3. Height-of-cut arm
(Figure 15).
14).
g310831