Before Use; Assembly; Assembling The Welding Protection Shield; Inserting The Flux Cored Wire - Parkside PIFDS 120 A1 Operation And Safety Notes

the Ssc short circuit power is
larger or equal to 2932.5 kW at
the interface point between the
operator's supply and the public
supply. It is the responsibility of
the installer or user of the device,
after consultation with the distribu-
tion system operator if necessary,
to make sure that the device is
only connected to a supply with
an Ssc short circuit power which
is larger or equal to 2932.5 W.
Note!
The device is only for use in
areas which are supplied with a
current load capacity of at least
100 A per phase.
z Before use
Take all parts from the packaging and
„
check whether the inverter flux cored
wire welder or parts show any damage.
If this is the case, do not use the inverter
flux cored wire welder. Contact the
manufacturer via the indicated service
address.
Remove all protective films and other
„
transport packaging.
Check that the delivery is complete.
„
z Assembly
z Assembling the welding
protection shield
Insert the dark welding lens
„
writing facing up into the shield body
(see Fig. C). The labelling on the dark
welding lens
the front of the protective shield.
Push the handle
„
the corresponding notch of the mask,
until it snaps into place (see Fig. D).
z Inserting the flux cored wire
plug from the mains socket prior to each
maintenance task or preparatory work in
order to prevent the risk of an electric shock,
injury or damage.
Note: Different welding wires will be
needed depending on the application.
Welding wires with a diameter of
0.6–1.0 mm can be used with this device.
Feed roll, welding nozzle and wire cross-
section must be compatible with one another.
The device is suitable for wire reels weighing
up to maximum 1000 g.
Unlock and open the cover of the wire
„
feed unit
Unlock the roller unit by turning the roller
„
mount
Pull the roller mount
„
(see Fig. F).
Note: Make sure that the end of the wire
does not come loose and cause the roll to
roll out on its own. The end of the wire may
not be released until during assembly.
Completely unpack the flux cored wire
„
welding spool
without difficulty. Do not release the wire
end yet (see Fig. G).
Place the wire reel on the shaft. Make
„
sure that the roll unwinds on the side of
the
Place the roll mount
„
it by pressing and turning it clockwise
(see Fig. G).
21
with the
Undo the adjustment screw
„
21 must now be visible from
22
from the inside into
Always unplug the mains
1 by pushing the latch up.
29
anti-clockwise (see Fig. F).
off the shaft
29
17 , so that it can unrolled
31 wire feed guide (see Fig. G).
29
back on and lock
20
27
and swing
17
GB