NETGEAR FS728TS Brochure & Specs page 2

FS728TS/
FS752TS
GA311 32-bit Gigabit
PCI Adapter
GA511 Gigabit PC Card Adapter
FS726TP 24 Port 10/100 Smart
Switch w/2 Gigabit Ports and PoE
FS726T 24 port 10/100 Smart
Switch with 2 Gigabit ports
FS750T2 48 port 10/100 Smart
Switch with 2 Gigabit ports
GS716T 16 port Gigabit
Smart Switch
GS724T 24 port Gigabit
Smart Switch
GS748T 48 port Gigabit
Smart Switch
NMS100 ProSafe Network
Management System
PMB0331 ProSupport OnCall
24x7 Support Service
ProSupport Maintenance
Services:
PMB0331 OnCall 24x7
PRR0331 XPressHW
PRR0331 ProSupport
XPressHW Support Service
IEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX
IEEE 802.3ab 1000BASE-T
IEEE 802.3z 1000BASE-X
IEEE 802.3x full-duplex flow control
FS728TS: 24 10/100 Mbps auto sensing Fast
Ethernet switching ports
FS752TS: 48 10/100 Mbps auto sensing Fast
Ethernet switching ports
4 Built-in RJ-45 Gigabit Ethernet ports for
10/100/1000 Mbps connectivity
2 SFP slots for fiber Gigabit Ethernet modules
Auto-sensing and auto-negotiating capabilities
for all ports
Auto Uplink on all ports to make the
™
right connection
IEEE 802.1Q Static VLAN (Up to 128)
IEEE 802.1p Class of Service (CoS)
Port-based QoS
IEEE802.3ad (manual) Link Aggregation
IEEE 802.1D Spanning Tree Protocol
SNMP v1, v2c, v3
RFC 1213 MIB II
RFC 1643 Ethernet Interface MIB
RFC 1493 Bridge MIB
RFC 2131 DHCP client
IEEE 802.1x
Port-based security by locked MAC addresses
Storm control for broadcast, multicast and
unknown unicast packets
Port-based ingress/egress rate limiting
SNTP
RMON group 1, 2, 3, 9
Private Enterprise MIB
Port Mirroring Support
Web-based configuration
Configuration Backup/Restore
Password Access Control
Firmware upgradeable
Half-duplex back-pressure control
Full-duplex IEEE 802.3x pause frame flow control
Forwarding modes: Store-and-forward
Bandwidth: 12.8 Gbps for FS728TS, 17.6 Gbps
for FS752TS
Network latency: Less than 20 microseconds for
64-byte frames in store-and-forward mode for100
Mbps to 100 Mbps transmission
Buffer memory: 128 KB
Address database size: 8,000 media access control
(MAC) addresses per system
Addressing: 48-bit MAC address
Mean Time Between Failure (MTBF): 100,000
hours (~11 years) for FS728TS, 84,000 hours
(~9 years) for FS752TS
Unit: Power, Master, Stack ID
Per Port: Link, Speed, Activity
Per Gigabit Port: Link, Speed, Activity, Stack
Power Consumption: 15 W maximum
100-240VAC/50-60 Hz universal input
Dimensions (H x W x D): 1.7 x 17.8 x 8.1 in.
(43 x 440 x 205 mm)
Weight: FS728TS: 5.73 / 2.6 (lbs/kg)
FS752TS: 6.57 / 2.98 (lbs/kg)
Operating temperature: 32 to 122° F (0 to 50° C)
Storage temperature: -4 to 158° F (-20 to 70° C)
Operating humidity: 90% maximum relative humidity,
non-condensing
Storage humidity: 95% maximum relative humidity,
non-condensing
Operating altitude: 10,000 ft (3,000 m) maximum
Storage altitude: 10,000 ft (3,000 m) maximum
CE mark, commercial
FCC Part 15 Class A
VCCI Class A
EN 55022 (CISPR 22),
EN 55024 (CISPR 24)
C-Tick
CE mark, commercial
CUL 60950 (Listed)/ EN60950
(Low Voltage Directive)
NETGEAR 5-year warranty
Category 5 network cables
Network card for each PC
Network software (e.g., Windows
FS728TS/FS752TS ProSafe 24/48 port Stackable
Smart Switch with 4 Gigabit Ports
Rubber footpads
Power cord
Rack-mount kit
Resource CD Installation Guide
Warranty/Support information card
AGM731F ProSafe 1000BASE-SX SFP GBIC:
Module with LC connectors for 50um or 62.5um
multi-mode fiber cable
AGM732F ProSafe 1000BASE-LX SFP GBIC:
Module with LC connectors for 9um single-mode
fiber cable
AGM733 ProSafe 1000BASE-LZ SFP GBIC:
Module with LC connectors for 9um single-mode
fiber cable
)
®