NETGEAR FS700TS Configuration Manual page 2

Creating a new VLAN
Working instructions
1) Log on to the device using the Smart Wizard or via the URL http://<<switchaddress>>
2) Browse to Switch – VLAN - Properties (Note: VLAN1 cannot be modified)
3) Click on Add
4) Set the VLAN ID and VLAN name
5) Click Apply
Assign ports to a VLAN
1) Browse to VLAN – Membership
2) From the VLAN ID list – select the VLAN you want to add ports to (by default all the
ports are members of VLAN1)
- Each port has a Current and Static box associated with -
3) Click on the Static box correspondent to the port until this show a U (Untagged)
symbol
4) Repeat point 3) for all the ports that are required to be member of the VLAN
5) Click Apply when completed
6) Browse to Interface PVID settings and set the PVID of each port assigned to the new
VLAN to the VLAN ID (for VLAN2 PVID = 2 , for VLAN3 PVID = 3....)
7) Click on Apply to finalise the changes
Verify the VLAN is working
Working instructions
1) Configure two PCs with unique IP address (within the same range) and same subnet
mask
2) Patch each PC in one of the ports that are members of the VLAN you wish to test
3) You should now be able to ping each machine from the other
4) Re-patch one of the machines to a port on a different VLAN
5) You should not be able to ping such machine from the others