Advertisement
Advertisement
Table of Contents
Related Manuals for ALLO STM
Summary of Contents for ALLO STM
- Page 2 Quick Installation Guide SIP THREAT MANAGER (aSTM) Revision 2.0...
- Page 3 Table of Contents Overview ........................1 Deployment Considerations ..................2 Initial Setup & Configuration ................... 4 Accessing the WebUI ....................5...
-
Page 4: Overview
STM- Introduction Overview Congratulations on your purchase of the Shield STM appliance to protect your SIP based PBX, VOIP Gateway deployments. This Quick Start Guide describes the steps involved in setting up the Shield STM Appliance. Package Content The STM Appliance package includes the following,... -
Page 5: Deployment Considerations
STM Rear View: Deployment Considerations The STM has been made to protect the SIP based PBX/Gateway Servers against SIP based network threats and anomalies. Thus it is recommended to deploy the STM along with the PBX/Gateway deployment as given in the following scenarios based on what is applicable in the user’s setup. - Page 6 STM- Introduction Scenario 2 In the case of PBX deployed in the LAN Setup, the following setup is recommended as it would help to protect against the threats from both Internal Network as well as the threats from the Public Cloud penetrated the Non SIP aware Corporate Firewall.
-
Page 7: Initial Setup & Configuration
Some of the PBX/Gateway devices may have an exclusive LAN/Mgmt Interface for device management purpose other than the Data Interface (also referred as WAN/Public Interface). In such cases LAN port of the STM should be connected to the Data Interface (aka WAN/Public Interface). -
Page 8: Accessing The Webui
Configure the STM Device IP Address from the “Device Settings” Page as per your local network range. Verify the IP address set to STM from the dashboard page. Once the user assigns the STM Device IP Address successfully, he can access the device using that IP address further. - Page 9 STM Appliance 1.0 On launching the STM WebUI, the web application will prompt enter the administrator credentials to login. Note: The WebUI has been made accessible only via HTTPS. The recommended browser for accessing STM WebUI is Mozilla Firefox. THE FULL VERSION MANUAL WILL PROVIDE YOU DETAILED INSTRUCTIONS...
Need help?
Do you have a question about the STM and is the answer not in the manual?
Questions and answers