Page 2
Microwave Sensor PD-MV1009 instruction FUNCTION AUTO=“AUTO”mode, enable the sensor to detect ON= Always on, about six hours later turn to “AUTO”mode OFF= Always off, about six hours later turn to “AUTO”mode ① ① LUX:When luminance is less than 10 LUX, enable the light to power on, for the use at night.
Page 3
Microwave Sensor PD-MV1009 instruction When the remote controller is input “ON” or“OFF”, the sensor enters always on/off mode, output power on/power off signal, the indicator will power on for one second every four seconds. It won’t withdraw this mode until six hours later.
Page 4
Microwave Sensor PD-MV1009 instruction INSTALLATION INSTRUCTION Ceiling (1)Before installing switch off power. (2)Take off the bottom-stand. (3)The bottom-stand is fixed on the selected position with inflated screw. (4)Connect the power and the load into the Ceiling connection-wire column sensor according to connection-wire diagram.