Table of Contents
Advertisement
Step 2
WARNING:
DO NOT ATTEMPT TO MAKE THIS CONNECTION UNLESS
YOU HAVE THE EXPERIENCE AND KNOWLEDGE TO DO SO.
INCORRECT CONNECTIONS MAY CAUSE MALFUNCTION OF CAR
STEREO AND OTHER ELECTRICAL SYSTEM COMPONENTS.
CONSULT AN MECP CERTIFIED INSTALLER IF YOU DO NOT HAVE
THE TOOLS OR KNOWLEDGE TO MAKE THIS CONNECTION.
Connect the free end of the yellow wire to constant power.
Step 3
The blue with white stripe wire
Step 3
goes between both ends of the cable.
In the middle is a connector that comes
apart. Pull the ends to disconnect them.
The female end is not used and can be
left alone.
Step 4
Cut off the male "bullet" end and
Step 5
connect this to 12-volt accessory power.
Step 5
The other cable interfaces included
in Interface Module IM-VW1 will not
be used. Use the Interface Cable
IC-AUD1 and remove the cable inside.
Interface Cable IC-AUD1 has a loose
Advertisement
Table of Contents
