Rainforest Automation EAGLE 3 Quick Start Manual

EAGLE 3 INFORMATION LABEL
Located on the side of the EAGLE 3 is the Information Label that identifies
each individual device. You may need the three numbers indicated below
to register the device. Please make a note of them:
Cloud ID: 123456
MAC: d8d5b90000000000
IN: e80f63cda5320a3d
LED INDICATOR LIGHTS
LED lights on the front of the device give you a quick way to check the
status of the EAGLE 3.
POWER (green) – this should be the only light on during
normal operation. It flashes during start up, and when there
is an update downloading.
CLOUD (yellow) – When this light is flashing there may be
problems with the connection to the cloud. It is off when
connected.
METER (red) – When this light is flashing the utility meter is
not connected to the EAGLE. It is off when connected.
You will see the green light flashing when the EAGLE is getting an
update from the cloud. Do not unplug the EAGLE while this is
happening.
Install Code
(16 characters)
MAC Address
(16 characters)
Cloud ID
(6 characters)
V1.00
EAGLE
WHAT'S IN THE BOX:
• EAGLE 3 energy gateway
• AC power adapter
• Ethernet cable
YOU WILL NEED:
• a broadband internet connection via Ethernet or WiFi
• a computer or device with a web browser
Quick Start GUIDE
Intelligent Energy Management
rainforestautomation.com