Rainforest Automation RFA-Z109 EAGLE Quick Start Manual

Energy Access Gateway Link to Ethernet

Quick Start Guide

FCC/IC Notices
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
manufacturer could void the user's authority to operate the equipment.
FCC/IC RF Exposure Statement
This equipment complies with FCC and Industry Canada radiation exposure limits set forth for an uncontrolled
environment. The antenna(s) used for this equipment must be installed to provide a separation distance of at least 8
inches (20cm) from all persons.
ICES-003 Compliance
This Class B digital apparatus complies with Canadian ICES-003.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.
Compliance Regulations For Australia and New Zealand
This equipment complies with the C-Tick labeling requirements for Australia and in New Zealand. As a radio
transmitter, this device complies with the requirements of AS/NZS 4268:2008 as designated in the
Radiocommunications (Short Range Devices) Standard 2004 for Australia and as required by the
Radiocommunications Regulations (General Users Radio License for Short Range Devices) Notice 2011 for New
Zealand. This device is a Category A device as defined in the Radiocommunications (Compliance Labeling -
Electromagnetic Radiation) Notice 2003.
EAGLE™
Changes or modifications not expressly approved by the
www.rainforestautomation.com
EAGLE™(beta)
Quick Start
V0.20