Display Contents - Technics SA-EH770 Service Manual

- Press an any operation button on the tuner/amplifier.
- To re-display the code, switch the power off (POWER STANDBY button),
and then switch power back on again.
2. For F61
- If F61 is displayed, the power will automatically be switched off and the
standby indicator will light up.
- F61 will be displayed for 3 seconds, and then the clock will be displayed.
- To re-display the code, switch the power on. F61 will be re-displayed, and
then after 3 seconds the clock will be displayed and the power will
automatically switch off.

7.3. Display contents

7.3.1. U70 CD/U70 DECK
(displayed automatically)
-
Problem or condition
A bus-line communications error has occurred as a result of the flat cables being
inserted incorrectly, thus preventing the system from operating.
-
If U70 is displayed on the tuner/amplifier, the tape deck or CD Changer cannot be
operated by remote control.
-
Correction Procedure
1. To check for correct insertion of flat cables.
- Insert each connectors until you hear a click.
- Insert the flat cables at the back of the unit in the order indicated. Refer to
Fig. 7-2.
Make sure the white side of the cables is on your right side. Refer to
Fig. 7-2.
25
Fig. 7-3.