Table of Contents
Advertisement
en Installation and connection
Tip: To collect condensation in the
condensation container again (e.g. if
you change where the appliance is
located), carry out these steps in re-
verse order.
Water outlet connection types
ATTENTION!
In the event of a blocked or covered
outlet, accumulated wastewater can
flow back into the appliance.
Before operating the appliance, en-
▶
sure that the wastewater drains
away quickly and eliminate any
blockages.
Drainage into a
siphon.
Drainage into a
wash basin.
2
1
16
Secure the con-
nection point with
a (12-22 mm)
hose clamp.
Secure the water
drain hose with a
hose guide at a
height of at least
80 cm and no
more than 100
cm.
Note: You can
use the Y-distrib-
utor → Page 26
to connect the
water drain hose
of an additional
appliance, such
as a washing
machine, to the
same siphon out-
let.
Push the water
drain hose fully
through the and
secure it using
fixing material.
Secure the elbow
at a height of no
more than 100
cm.
Drainage into a
gully.
4.5 Aligning the appliance
In order to reduce vibrations and
noises, align the appliance correctly.
To align the appliance, turn the ap-
▶
pliance feet. Check that the appli-
ance is level using a spirit level.
All appliance feet must stand firmly
on the ground.
4.6 Connecting the appliance
to the electricity supply
Insert the mains plug of the appli-
1.
ance's power cable in a socket
nearby.
The connection details of the appli-
ance can be found under Tech-
nical data → Page 41.
Check the mains plug is inserted
2.
properly.
Push the water
drain hose fully
through the and
secure it using
fixing material.
Secure the elbow
to the gully.
Advertisement
Table of Contents
