Table of Contents
Advertisement
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked
with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is
marked with the letter L or coloured RED.
Under no circumstances should either of these wires be connected to the earth terminal of the
three pin plug, marked with the letter E or the Earth Symbol.
2.2.2. Before use
remove the Connector Cover as follows.
2.2.3. How to replace the Fuse
1. Remove the Fuse Cover with a screwdriver.
2. Replace the fuse and attach the Fuse cover.
3. SERVICE CAUTION
3.1. EEPROM DATA FOR SPARE PARTS OF THE MAIN C.B.A.
When the Main C.B.A. is replaced, the fixed and average data must be changed by Tatsujin kit
according to the Movie Camera's suffix.
Then, confirm and/or adjust the VTR and Camera section one by one.
3.2. SERVICE EXTENSION CABLES.
This models is required the following extension cables for all connections.
Note 1:
5
Advertisement
Table of Contents
