Advertisement
for the RF test signal to transmit and trigger the fire relay of the
Ei413. This will override the fault condition and reset the Ei413.
Then reset the panel to standby mode as per the manufacturer's
instructions.
House Coding
Once wired to the panel, it is essential to House Code the
Ei413 to all the other Ei Electronics RF Alarms and devices in
the system to ensure they will not communicate with nearby
systems. Failure to house code the system may also result in a
system malfunction.
1) Press and hold the House Code button until the RF indicator
lights up blue, then release.
2) House code all other RF Alarms and devices in the system.
Consult the instruction manuals on how to house code the
Alarms and devices. It is essential that each individual Alarm/
device is put into House Code mode in its final location.
3) Check the number of flashes on the Ei413 and on every
other device. They should correspond to the total number
of devices in your system. A system with 3 Smoke Alarms
17
Advertisement
