Operation - Tarmo 330086 Manual

ASSEMBLY
Attach the inlet connector (8) to the pump
(1) and tighten by turning clockwise. En-
sure a tight connection to avoid leakage.

OPERATION

Immerse the pump (1) into water.
IMPORTANT:
1. Do not remove the pump from water when operating.
2. Ensure the shower head is securely attached before use.
3. Power off the pump after use.
RECHARGING
Open the socket cover (4) by turning an-
ti-clockwise.
AUTO-STOP SAFETY FUNCTION
The device will stop automatically when the voltage is lower than 2.7 V. Note: Do not restart the device but recharge it.
MAINTENANCE INSTRUCTIONS
For the shower
1. Detaching the parts
Stop the device by pressing the power
switch (2).
330086_retki-_ja_mökkisuihku_ko_A5.indd 2 330086_retki-_ja_mökkisuihku_ko_A5.indd 2
Insert the O-ring (10) into the outlet con-
nector (9).
Push the power switch (2) to start.
Insert the USB charging cable (15) into the
charging socket (3). Note: Red LED light:
Battery is being charged. Blue LED light:
Battery is fully charged.
Remove the hose (7) from the pump (1)
and shower head (11). Drain any water
from the hose.
Attach the outlet connector (9) to the show-
er head (11) and tighten by turning clock-
wise.
Position the shower head (11) using the
supplied hook (13) or holder (12).
Plug the USB charging cable (15) into: Mo-
bile phone charger, car USB output, laptop
USB output or other power source.
Remove the O-ring (10) from the outlet
connector (9) and store the parts safely.
11.3.2021 14.48.24 11.3.2021 14.48.24