Rear Panel - Audiolab ICE-2400 User Manual

Rear panel

1. Channel 1 XLR Input This XLR input is a
balanced input. Connect this input to the left
output of your mixer.
2. Channel 1 Link Socket This balanced socket
is used to link another amplifier.
3. Channel 2 XLR Input This XLR input is a
balanced input. Connect this input to the left
output of your mixer.
4. Channel 2 Link Socket This balanced socket
is used to link another amplifier.
5. Operation Mode Selector This switch is used
to choose the operating mode of the power
amplifier: Mode stereo: 2 inputs(channel 1 and
2) and 2 outputs are used. Mode parallel: 1
input(channel 1) and 2 outputs are used. Mode
bridge: 1 input(channel 1) and 1 output are
used.
6. Input Sensitivity Selector This selector
allows to choose the input sensitivity: either
0.75V, 1.0V, 1.5V).
7. ON/OFF Switch
switch ON, the amplifier adds low- frequen-
cy compensation so as to enhance speaker
output. The results (the actual change in the
low-frequency balance) will vary according to
the speaker type.
8. Channel 1 Turn Lock Output Connect this
turn lock output to a speaker. The branching is
+1,-1(except in bridge mode where the branch-
ing is +1,+2 ).
9. Channel 2 Turn Lock Output Connect this
turn lock output to a speaker. The balance is
+1,-1.
10. Wiring Terminal According each output
11. AC Cord Plug this cord into the power supply
12. Air Entrance Speakon connector This part
If you set this
mode , connect with split plug or bare wire
to Out 1,Out 2 , BRIDGE .
socket. (Before using the power amplifier,
check if the power supply is 220V).
is the air entrance. Don't obstruct it.
P. 5
AUDIOLAB ICE SERIES