Maintenance - Electrolux FSF3 Installation, Use And Maintenance Instructions

From the "Secondary" MENU press the
this function.
. The machine cycles data cannot be changed.

MAINTENANCE

Before proceeding
procedures, read carefully the "Safety warnings".
Maintenance is very important to have a perfectly
efficient machine.
The frequency is indicative and depends on many
factors such as:

Amount of work done by the machine.

The hardness of the water, which causes a greater
or lesser scaling of the boiler heating element.

Amount of dust in the air.

Other local working conditions.
BY THE OPERATOR
Daily
Air filter fan:
Lift the filter frame, remove from the network all dirt,
dust, lint and dirt, using a brush or compressed air,
reassemble
Weekly
Clean all the external parts of the machine with a soft
and dry cloth.
Compressed air condensate:
any condensate,
deposited into the filter cups is
automatically exhaused.
Monthly
Anti-adherent coated surfaces:
Clean all the anti-adherent coated surfaces with a soft
cloth and an alkaline detergent; proceed carefully and
avoid scratching, DO NOT USE : aggressive product,
abrasive brushes and steam cleaners.
key to enter
with the maintenance
water or
Greasing
Put the grease, up to filling, in the 4
distributors identify on the machine with the
following symbol
truck, rear press, sleeve tensioning), use a
grease pump, then clean up the excess. We
recommend using a lithium grease with
mineral oil base, viscosity ISO VG 100, type
LGMT2 (SKF) or AFB-LF (THK).
Sliding elements:
Clean from dirt and moisture, and only in case of difficult
sliding spray with silicone spray the following parts:
Six monthly
Semestrale
Air-breaking net
oil,
Remove from the network all dirt, dust, lint and dirt,
using a brush.
Compressed air filters:
remove the filter cups, clean with mild soap and water,
replace all parts back. Replace the filter element every
2 years or when the pressure drops to 1 bar (0.1MPa).
When the filter cup or the filter element are damaged,
replace them immediately.
Greasing:
- 13 -
(sliding front
pivot sleeve clamp and
cylinder guide for cuff
placket press