Table of Contents
Advertisement
Charging Your Product
ATTENTION: If the ambient temperature is too high or the battery temperature is higher than
60°C due to continuous high-power discharge, the product cannot be charged. When the
battery temperature is less than 55°C, the charging function will automatically resume. If it is not
used for a long time, it is best to fully charge it every three months before storing; it is best to fully
charge the battery.
1. LCD Battery Display
There are 5 segments to the battery, approximating 20%-40%-60%-80%-100% capacity.
As you use your product, segments will disappear from the display, indicating the remaining
charge. When charging your product you will notice a battery segment blinking at a 1 second
interval status. Once your product is fully charged, all battery segments will be lit and remain solid.
2. Charge Through Flash Portable Solar Panel
A. Place your Flash Portable Solar Panel where it will get as much strong direct sunlight as possible.
B. Connect the output port of the Flash Portable Solar Panel with the input port of the product to
start charging. You will know the product is being charged when the LCD display indicators blink.
The product is fully charged when all battery indicators stop blinking and remain solid.
Notes:
The actual charging e ciency can vary widely depending on weather, ambient temperature,
sunlight's strength, the angle that the Flash Portable Solar Panel faces to direct sunlight and
other factors. The maximum output voltage of the Flash Portable Solar Panel should not exceed
23.5V. It is recommended to use Flash Portable Solar Panels with an open circuit output voltage of
10.8-23.5V. The maximum electric current can reach A3.
2
Advertisement
Table of Contents
