Navitar 371MCZ125 Installation Instructions

Installation of Navitar/ NuView Series 371 lens on Sanyo model PLV-
WF10 projectors.
TOOLS REQUIRED: PHILLIPS HEAD SCREWDRIVER

Disassembly:

1. Disconnect unit from power source.
2. Remove four (4) screws from top cover, then remove two (2) screws from the lower
cover Remove cover and set aside for re-installation.

Assembly:

1. Insert keyed portion of the lens adapter into the projector and rotate lens lock lever
downward while squeezing it with stationary handle.
2. Replace the top and bottom covers removed in step 2 of the disassembly procedure
above.
3. To focus, gently twist the front of the lens. To zoom, loosen thumbscrew and twist
the knurled zoom ring. Re-tighten thumbscrew. CAUTION: When focusing, be sure
not to twist lens completely out of the adapter!