Table of Contents
Advertisement
REGULATORY AND WARRANTY INFORMATION
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation
is
subject to the following two
conditions:
(1)
This
device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This
product has been tested and complies with the specifications for a Class
B digital device, pursuant
to
Part 15
of the FCC Rules.
These
limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This
equipment generates. uses,
and can radiate radio frequency energy and, if
not
installed and used according to the instructions, may cause
harmful
interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular
installation.
If
this equipment does cause
harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient
or relocate the receMng antenna.
• Increase
the separation between
the
equipment and devices.
• Connect the equipment to an outlet other than the receiver's.
•
Consult a dealer or an experienced radio/TV technician for assistance.
FCC Caution: Any changes or modifications
not
expressly approved
by
the party responsible for compliance could void the user's authority
to operate this equipment.
2.4 GHz operation of this product in
the USA
is
firmware-limited
to channels 1 through
11.
Selection of other channels is not possible.
Operations in
the
5.15-5.25GHz
band
are
restricted
to indoor usage only.
This
device meets all the other requirements specified in
Part
15E,
Section 15.407 of the FCC Rules.
FCC Radiation
Exposure
Statement
This equipment complies with FCC radiation exposure limits set forth
for
an uncontrolled environment. This equipment should be
installed and operated with minimum distance 35 cm between the radiator and your body.
This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in
accordance with FCC multi-transmitter product procedures.
Innovation, Science and Economic Development Canada Statement
CAN ICES-003(B) /
NMB-003(B)
This device complies with
ISED's
license-exempt ASS
standards. Operation is subject to the following two conditions: (1) This
device
may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired
operation of the device.
For product available in the USA/Canada market, only channel 1-11 can be operated for 2.4 GHz. Selection of other channels is not
possible.
The device could automatically discontinue
transmission
in case of absence of information to transmit, or operational failure. Note that
this is not intended to prohibit transmission of control or signaling information or
the
use of repetitive
codes
where required by the
technology.
Innovation,
Science and Economic
Development
Canada
Radiation
Exposure Statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 35 cm between the radiator
&
your
body.
This device and its antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in
accordance with ISED multi-transmitter
product
procedures.
Restrictions in the 5 GHz Band
The
device for the
band
5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel mobile
satellite systems.
This device has been designed to operate with an antenna having a maximum gain of 4.09 dBi and 3.81 dBi at 2.4 GHz and 5 GHz
Hide quick links:
Advertisement
Table of Contents
