Charging The Device - UFESA EasyOpen Instruction Manual

Take the foil cutter off and put onto the bottleneck, hold with fingers by force, rotate the
bottle in parallel for more than one circle, and cut off the foil seal. (Fig. A)
Hold the bottle firmly with one hand and hold the wine opener with the other hand. Place
the bottom of opener body on top of the wine bottle to ensure the opener body remains in
line with the wine bottle as much as possible. (Fig. B)
Press the extract button and hold, slightly press the opener body downward at the same
time. The spiral will turn in a clockwise direction and enter the cork, then gradually remove
it from the bottle in 6-10 seconds. When the cork is entirely pulled out, automatically. Re-
lease the button and take the opener off from the bottle. (Fig. C)
Press the upper release button and hold it for 5-9 seconds, the cork automatically comes
out from the opener, release the button, and complete the opening process. (Fig. D)
For use the POURER insert it on the bottleneck tilt the bottleneck to pour wine out of the
bottle trough wine pourer. (Fig. F)
If the bottle is not empty insert the VACUUM STOPPER into the bottleneck firmly. Then pull
the handle up and down for about 15 times (if bottle has half wine left) until you notice
certain pressure. (Fig. G)
Store the bottle in a wine cabinet or refrigerator for better preserving effects, no longer
than 7 days. Is not recommend to store the bottle horizontally.
*This product is suitable for corks with a diameter of 20 to 24mm and a height of 44mm.
*This is suitable for wine bottles with a bottleneck outer diameter of no more than 35mm
and inner diameter from 17,5mm to 23mm.
*The pourer product is suitable for wine bottleneck inner diameter of 18 to 19mm.
* The vacuum stopper is suitable for bottles with bottleneck inner diameter from 17,5 to
20mm.

CHARGING THE DEVICE

Before the equipment is used for the first time, it is recommended to charge it 12 hours.
Plug power cord directly into unit. During charging, the charge indicator keeps blue.
The wine opener is completely handy to carry and can be charged anywhere with the USB
cable (6).
Comes with built-in Ni-MH battery, a full charging time is about 15 hours and offers around
50 bottes aperture.
First insert the plug on the end of the USB charging cable lead into the unit and then con-
nect the USB charging cable to the USB interface. This appliance is suitable for Max. 2A
charger, computer and other power interface.
Note: This product is recommended for cordless use. If your battery is completely run
down, allow the unit to charge for 6-8 hours (switched OFF) before using. (Not recommen-
ded use while charging).
If the product is not in use, the standby time is one month. After more than a month, charge
it again.
13