Table of Contents
Advertisement
Changing a Programme
Follow the steps below to change a
programme while in operation.
Open the door and press the
Programme Selection button to
select a new programme.
After closing the door, the new
programme will resume the
course of the old programme.
NOTE: Open the door slightly at first to
stop a programme before it is complete in
order to avoid water spillage.
Cancelling a Programme
Follow the steps below to cancel a
programme while in operation.
When the door of your machine
is opened, the most recently
selected programme will show on
the display.
Press and hold the Programme
Selection button for 3 seconds. '1' will
be shown on the Display .
The water discharge process will start after the
door of the machine is closed and will continue
The water discharge process will start after the
for 30 seconds. A buzzer will sound 5 times
door of the machine is closed and will continue
when a programme is cancelled.
for 30 seconds. A buzzer will sound 5 times
when a programme is cancelled.
Switching the Machine Off
"00" will be shown on the displaywhen a
programme is complete. A signal will also
sound 5 times. You can then switch your
machine off using the Power On/Of f button.
Disconnect the plug and turn
NOTE: If any button is not pressed
on the ready state, the machine turns off
automatically after 15 minutes.
NOTE: Do not open the door before a
programme is complete.
NOTE: Leave the door slightly open at
the end of a wash programme to speed up
drying.
NOTE: If the door of the machine
is opened or the power is cut during
operation, the program will continue when
the door is closed or the power returns.
Buzzer Sound Control
To change the buzzer sound level,
follow the below steps:
1. Open the door and press Delay (5)
And Options (6) buttons simultaneously
for 3 seconds.
2. When sound setting is recognized,
buzzer gives a long sound and machine will
display last set level, from "S0" to "S3".
3. To decrease sound level press Delay
button (5). To increase sound level, press
Options button (6).
4. To save the selected sound level, turn off
the machine.''S0'' level means all voices are
off. Factory setting is "S3".
Save Power Mode
To activate or deactivate Save Power Mode,
follow the below steps:
1. Open the door and press Half Load (4)
and Delay (5) buttons simultaneously for 3
seconds.
EN - 19
off the water tap.
Advertisement
Table of Contents
