Information Display Control; Headlamp Exit Delay; Power Windows - Ford TOURNEO CUSTOM Quick Reference Manual

INFORMATION DISPLAY
CONTROL
AUTOWIPERS
A High sensitivity
B On
C Low sensitivity
Use the rotary control to adjust the
sensitivity of the autowipers. When you
select low sensitivity, the wipers will
operate when the sensor detects a large
amount of water on the windshield. When
you select high sensitivity, the wipers will
operate when the sensor detects a small
amount of water on the windshield.
Tourneo Custom/Transit Custom (TTF) Vehicles Built From: 12-01-2015, CG3580en enGBR, Edition date: 12/2014, First Printing
AUTOLAMPS
The headlamps will switch on and off
automatically in low light situations or
during inclement weather.
Note: You may have to manually switch the
headlamps on in severe weather conditions.

HEADLAMP EXIT DELAY

After you switch the ignition off, you can
switch the headlamps on by pulling the
direction indicator lever toward you. You
will hear a short tone. The headlamps will
switch off automatically after three minutes
with any door open or 30 seconds after the
last door has been closed. You can cancel
this feature by pulling the direction indicator
toward you again or switching the ignition
on.

POWER WINDOWS

To reduce wind noise or pulsing noise when
just one window is open, open the opposite
window slightly.
Bounce-Back
The driver side window automatically stops
and reverses some distance if it detects an
obstacle while closing.
Overriding Bounce-Back
1. Close the window twice until it reaches
the point of resistance and let it reverse.
7