Advertisement
CONNECTIONS
Instruments inputs
(Ch. 1 and 2)
UNICO X
Class–A High Voltage Preamp / No Integrated Circuits / No NFB
INSTRUMENT IN
Ø
10V
GAIN
WARM
LOW
PARAMETRIC MIDS
700 Hz
300 Hz
1
MIC IN
INSTRUMENT IN
P48
10V
GAIN
RESON
flat
2
MIC IN
P48
GAIN
LOW
PARAMETRIC MIDS
700 Hz
gain
3
300 Hz
3.3 KHz
Microphones input
(condenser or dynamic)
or DYN contact microphones
(Ch. 2 and 3)
TO external effects
UNBALANCED
AUX output to effects or
stage monitor
HIGH
REV / AUX
VOLUME
AUX OUT
DECAY
gain
3.3 KHz
LOW
MID
HIGH
REV / AUX
VOLUME
240 Hz
150 Hz
INSERT
HIGH
REV / AUX
VOLUME
STEREO IN
L
R
4
5
LINE
Stereo input
DI output to mixer
EFFECTS RETURN
QUICK START
TURN ON THE AMP
FROM external effects
Check the MASTER volume, GAIN and channel VOLUME pots are completely closed or the MUTE is engaged.
Connect the power cable to mains and switch on the amp.
If a ground noise (hum at 50-60Hz) occurs, flip the ground lift switch (GND LIFT) on the rear panel.
CONNECTIONS
Connect microphones to the XLR or instruments to the ¼"jack sockets. Remember to activate the P48 phantom
power on the XLR when using condenser microphones and DYN P48 contact microphones or the 10V on the
¼"jacks when using STAT pickups or other electrostatic microphones. LINE signals can be connected via the
stereo 1/
"jack.
8
LEVELS SET UP
Playing (or singing) loud, turn the GAIN up until the OL red LED starts to blink, from there turn it back down a
little. Now open the MASTER between 30% and 50% finally adjust CHANNEL VOLUME as needed.
OTHER FEATURES
Once the levels are properly set, you can shape your sound with the EQ and the WARM filter (on ch. 1) or cut
the selectable 150 Hz or 240 Hz with the RESON notch filter (on ch.2) and set the amount of REVERB you want
UNBALANCED
on each channel and its return on the MASTER. The LOW CUT button will high pass the signal to the MASTER.
LINE output to
EXTERNAL EFFECTS
other amp
You can connect external effects on the MASTER (affecting all channels) using a Y-cable: connect the stereo jack
to the INSERT socket and the two mono jacks to the input and output of the external pedal.
In alternative, for parallel connection, connect the external effect input to the AUX OUT and return from the
effect into ch. 5. Set the amount of signal you want to send to the effect w/ the REV/AUX pot on each channel.
If you don't want to use the internal reverb module, simply turn the REVERB MASTER down to zero.
USER MANUAL available online at www.schertler.com
RELATED PRODUCTS
REVERB
MASTER
master
LINE OUT
D.I. OUT
VOLUME
SWISS
MADE
BALANCED
CA JM JM
¼"jack cable
TEDDY
VOLUME
Stage monitor
PEDAL
CA XF XM
XLR cable
BAG
DYN P48
contact
microphones
STAT
pickups
Advertisement
