Advertisement
You will notice the four walls (A), (B) and (C 1-2) that fits into the floor (D).
There is a serving counter (G) that fits onto the front wall (A). To ensure a better fix,
there is a shoe (H) between the wall and counter.
There is a roof (E) that fits over the front wall. The flag above the roof has two add
on pieces (F 1-2) to give a chequered effect. The roof has a corrugated iron
engraving that must face upwards.
PREPARING THE CUT PIECES
Firstly, remove all the laser cut parts from the sheets. The sheets can be discarded.
Clean the edges of the parts if there are any tiny bits where the parts were fixed to
the sheets. This can be done with your knife or even your thumb nail.
We recommend that you start by sanding your finished product with a very light
sandpaper to ensure a smooth finish for the end product.
WORD OF ADVICE
We would strongly advise you to do a quick dry assembly before you start gluing the
laser cut parts together. Lay out all the parts on your work surface and make sure
4
Advertisement
