Noises - Siemens WT43HVP8DN Installation And Operating Instructions Manual

Table of Contents

Advertisement

Noises

en
The volume for the audible signal at
5.
the end of the programme is shown
on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Ready in" time button or
6.
the drying time button to change the
volume.
Turn the programme selector
7.
clockwise to position 4.
The volume for the audible button
8.
signal is shown on the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Ready in" time button or
9.
the drying time button to change the
volume.
You can select other positions
Note:
with the programme selector; however,
you will be unable to change these
settings.
Finishing setting mode
Turn the programme selector to the
"Off" position once you have set the
required spin speed and the volume.
The settings have now been saved.
28
>
Noises
During drying, particularly in the
N ote:
N o i s e s
initial phase, operation of the appliance
results in noise from the compressor
and pump. This is perfectly normal and
does not impair proper functioning of
the appliance.
From time to time, the compressor in
the dryer generates a humming noise.
However, the volume may vary
depending on the programme and
progress of the drying process.
Every now and then, the compressor is
ventilated. This creates a whirring noise.
The condensation is pumped into
the condensate container by a pump.
This generates pumping noises.

Advertisement

Table of Contents
loading

Table of Contents