VTech Sleepy Sloth Cot Light Instruction Manual page 5

INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of
the unit. Use a screwdriver to loosen the
screw and then open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 3 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
5
5
5