Included In This Package; Battery Removal And Installation - VTech SWITCH&GO DINOS Instruction Manual

Hide thumbs Also See for SWITCH&GO DINOS:
Table of Contents

Advertisement

INCLUDED IN THIS PACKAGE

Switch & Go Dinos Thrash the T-Rex
3 Discs
Quick Start Guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child's safety.
NOTE:
Please save this Instruction Manual as it contains important information.
INSTRUCTIONS

BATTERY REMOVAL AND INSTALLATION

1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of the unit. Use a
screwdriver to loosen the screw and then open the battery cover.
3. If used batteries are present, remove these batteries from the
unit by pulling up on one end of each battery.
4. Install 2 new AAA (LR03/AM-4) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries or
fully charged Ni-MH rechargeable batteries
are recommended).
5. Replace the battery cover and tighten the
screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
3

Advertisement

Table of Contents
loading

Table of Contents