Setup And Menus; What Can Be Done Through The Menus; How To Use The Menus With The Front Panel Controls And On Screen Display; Navigating The Menus Using The Front Panel Controls - NHT Xd system User Manual

Setup and Menus

The Controller is very flexible and can be customized in
almost every aspect. In this chapter we go through the
Controller's menu system and look at how you can setup
your system to best suit your needs.
To get the most out of your audio-video system, carefully
read through this chapter. Even if someone else sets up
your system, it is good to know all the possibilities the
Controller can accommodate.

What can be done through the Menus?

The Main menu system is divided into the following
submenus:
NHT speaker wizard - If you own NHT speakers, the
Wizard automatically sets all the crossover frequencies
and assigns EQ (as needed) to any combination of NHT
speakers.
Speaker setup - Changes the Controller's speaker set-
tings. You can also let Controller auto calibrate the set-
tings. Both manual and automatic speaker calibration is
available.
Source setup - Changes the parameters of the ten pre-
set Sources and the AM/FM Tuner.
Audio setup - Changes the processing mode parame-
ters and tone controls.
Tuner setup - Lets you set the tuner presets and modes
like Auto or Manual tuning.
Trigger setup - There are three trigger jacks (i.e. exter-
nal device controllers) on the back of the Controller and
this menu changes the setting of the triggers. Two of
them are programmable using this menu.
Misc setup - Lets you change things such as TV system
format, proximity mode and setup lock.
NOTE: By far, the easiest way to use the Controller's
menu is to connect a video monitor or TV to one of the
Video Out jacks on the unit (for more on connections, see
Video connections, page 8) and use the Controller's
remote control to navigate the menus.
How to use the Menus with the Front Panel Controls
and On Screen Displays
As previously mentioned, using the remote control and
the OSD is the fastest and most intuitive way to use and
setup the Controller and thus highly recommended.
Note: Analog level indicators are not shown on the front
panel display and OSD is required for auto calibration
and the naming of sources. All other settings can be
accessed from the front panel.

Navigating the menus using the front panel controls

1. Wave hand near front panel or press any key adjacent
to the MENU text on the front panel display to start. The
text "Main menu" should now appear on the screen and
OSD.
2. Enter the Menu by pressing the right arrow key.
3. In the selected menu, do as before - select the desired
menu or submenu item by scrolling up and down with the
touch wheel's up and down arrows (select with the right
arrow).
4. When all changes are made, press the menu button
again. Press the touch button adjacent to the EXIT on the
display if you want to exit without saving changes.

Navigating the menus with the remote control

1. Press MENU button to start. The text "Main menu"
should now appear on the Controller's front panel display
and OSD will additionally display the seven menu setup
options plus "Exit".
Note: Press ESC button on the remote at any time if you
want to exit without saving changes.
2. Select the menu you want to edit using the Up or Down
arrow button on the remote. The front panel display will
show the menu name on the top row and selected item
on the bottom row one at a time, while the OSD will show
a small arrow in front of the menu item. Press the OK
button to select the menu item.
3. In the selected menu do as before - go to the wanted
menu item or submenus with the Up and Down arrow
buttons and edit it with the remote control's Left and Right
arrow buttons.
14