Advertisement
Assembly Instructions
*Do not tighten screws until assembly is complete*
Step 4: Connect the L-Shaped Pipe for Upper
Board (4) and the Upper Board (7) using four
M6x20 Flat-End Screws (D). The connect the L-
Shaped Pipe for Upper Board (4) and the
Square Pipe (13) with two M6x45 Flat-End
Screws (E).
E
© 2021. EMS Mind Reader, LLC. All Rights Reserved.
Step 5: Insert the parts finished in Steps 3 & 4
into the Table Leg (1) and screw in all four
Rotating Handles (I).
I
E
4
Step 6: Place the Pen Holder Strip (11) on the
Upper Board (7); and connect the Barrier Strip
(12) to the Middle Board (8) using two M6x20
Flat-End Screws (C).
Advertisement
