Advertisement
Installation to Threaded Rod
Attach projector mount assembly (A) to two 3/8-16 threaded rods (not included) using two 3/8-16 hex thin nylon-
insert locknuts (not included) as shown in figure 1.1 or figure 1.2.
Skip to step 6.
3/8 -16 THREADED ROD
(NOT INCLUDED)
A
3/8 -16 HEX THIN
NYLON-INSERT
LOCKNUT
(NOT INCLUDED)
Installation to Extension Column
Screw projector mount assembly (A) onto extension column (sold separately) as shown in figure 2.1. Note: For
3/4" extension columns, reducer ACC 913 will be required as shown in figure 2.2. Tighten swivel stop screw
against extension column or reducer using security allen wrench (B). Note: Swivel stop screw is used to jam
against threads of extension column or reducer to prevent any excess movement of projector mount assembly
(A). Do not overtighten screw; overtightening screw will damage threads making it difficult to separate products.
A
SWIVEL STOP SCREW
fig. 2.1
Visit the Peerless Web Site at www.peerlessmounts.com
Accessories listed in the included sheet, as well as other parts,
can be ordered through Peerless by calling 1-800-729-0307 or
visiting www.peerlessindustries.com.
FRONT OF
MOUNT
fig. 1.1
1 1/2" EXTENSION
COLUMN
BACK OF
MOUNT
SWIVEL STOP SCREW
5 of 8
3/8 -16 THREADED ROD
(NOT INCLUDED)
A
3/8 -16 HEX THIN
NYLON-INSERT
LOCKNUT
(NOT INCLUDED)
A
fig. 2.2
ISSUED: 11-16-05 SHEET #: 055-9447-2
For customer service call 1-800-729-0307 or 708-865-8870.
FRONT OF
MOUNT
fig. 1.2
3/4" EXTENSION COLUMN
ACC 913
BACK OF
MOUNT
Advertisement
