Page 2
HONBIKE, and carefully follow the instructions. If you have any questions or do app to activate the electric system of your Uni4. You can scan the QR code or go to www.honbike.com to download the app and learn how to register not understand something in this manual, take responsibility for your safety and consult HONBIKE.
Accessories & Tools ......................2 Warranty ....................... 35 Key features ......................... 4 Warranty notes ......................36 Frame number ........................ 4 Exclusions ........................37 Get your HONBIKE ready ................. 5 Special notes ........................37 Unboxing ...........................5 Disclaimer ......................38 Install the front fender ....................7 Declaration of conformity ..................38 Install the front wheel ....................
Hex Key Front Reflector (US Only) The front reflector is only compatible with the US version of HONBIKE Uni4, therefore the above accessories are not included in the toolkit in countries and regions outside the US. Owner's Manual Manuel du propriétaire...
Key features Frame Handlebar Integrated display Aircraft-grade 7000 series LCD screen aluminum material enables sturdy Built-in bluetooth and minimalist frame design. Riding status display Rear Hub Motor Carbon Gates Belt Drive High efficiency 11,000km maintenance free High reduction ratio 1:13 Gates Carbon Drive belt delivers a smooth and quiet ride.
HONBIKE Uni4 correctly. HONBIKE packaging is delicately designed for the safe transportation of electric bicycle. We recommend that you keep HONBIKE original packaging for at least one month in case you need to send your HONBIKE Uni4 for service or maintenance.
Install the front fender Install the front wheel 1. Hold on to the middle part of the axle tightly with one hand, and loosen the axle nut on any 1. Take out the front fender and attach it to side anticlockwise with a socket spanner. the front fork, as shown on the left.
1.5mm Adjust the right brake lever The left brake lever of HONBIKE Uni4 is adjusted at the factory. Please follow the steps below to adjust the right brake lever. 3. Install the axle on the front fork. The exposed part of the axle shall be about 1.5mm when the spacer nut is strung on the axle.
Install the pedals Saddle height adjustment 20~25Nm 1. Use Hex Key #5 to loosen the clamp bolt anticlockwise until the saddle can be moved with little force. Right: Be careful not to loosen this bolt too much. Take the right pedal with the label R.
Adjusting the saddle position and angle Recommended torque values 1. Remove the rubber plugs on the bolts and keep them safe. Use Hex key #5 to loosen the saddle adjustment bolts. 2. Once the bolts are adequately loose, the saddle can be moved forward or back and angled up or down.
When the ambient brightness is low or when riding at night-time, please turn on the headlights. Riding Mode Short press the Plus or Minus button to switch between different riding modes. Uni4 is equipped with four riding modes. 1. Power button 7. Riding Mode 2. Plus button/ Light button 8.
Maximum power mode for high-speed riding. Non-US version: Press and hold the "walk mode" button for 2 Eco mode is the default configuration when your Uni4 is first turned on. seconds or twist the throttle, the bicycle will automatically go into...
When the interface displays P4, the backlight brightness speed interface. Please check www.honbike.com for particular error can be adjusted. code meanings and solutions. When the alarm icon and error code Short press "Power"...
HONBIKE is not responsible for any problems caused by customers using empty Please use the HONBIKE Uni4 charger to charge the battery. Do not charge the battery with chargers other than the charger provided by HONBIKE. HONBIKE shall not be held responsible batteries without permission.
We strongly recommend that you contact your local e-bike authority before riding below for adjustment before riding. If the HONBIKE Uni4 is not the right size for you, please do not try to maneuver it to avoid accidents. The minimum height of it in public so that you are aware of the relevant laws and regulations.
• Before you set off for the first time, check whether the battery is fully charged. how to control the HONBIKE Uni4 with luggage in a safe area before riding on public roads. • Check if the front light and rear light can be turned on normally and if the front and back reflectors are not damaged.
Your HONBIKE will be double checked at the factory, but due to factors such as to the braking effect of the HONBIKE Uni4 before riding it in traffic on a public potential shipping or tampering by a third party, we recommend you check the road.
Or you can hold the brake lever firmly to ensure • It is prohibited to ride up and down stairs or jump over any obstacles on HONBIKE Uni4 . that the power is cut off.
• HONBIKE Uni4 can withstand light rain and small splashes. The electrical parts Remove any oil residue on the brake discs. of HONBIKE Uni4 have an Ingress Protection rating of IP65. But it does not mean • Inspection: Brakes, tires, lights, and belt should be inspected regularly.
• HONBIKE Uni4 is equipped with a high speed motor, when you roll the bicycle backward, Please do not replace it without permission. To replace, please find a professional...
HONBIKE is the owner's responsibility and at the owner's expense. item and is the sole remedy of the warranty. This warranty commences from Please visit www. honbike.com to find out how to pack your HONBIKE Uni4 to ensure safe the date of purchase.
• Bicycles for which proof of purchase, frame number and other relevant documents cannot be provided. HONBIKE declares that HONBIKE Uni4 conforms to the requirements of: • Normal wear and tear on parts such as tires, brake pads and paint are not covered Machinery Directive (2006/42/EC), the EMC Directive (2014/30/EU), and the Radio by the warranty.
HONBIKE is limited to the cost of repairing or replacing the failed product or component at the discretion of HONBIKE, either within or outside of warranty periods, and does not extend to any loss or damage which may be caused as a consequence of misuse or failure of the products.
Need help?
Do you have a question about the Uni4 and is the answer not in the manual?
Questions and answers