Universal EXPLORE HOME HONOLUA U012750 Assembly Instructions

EXPLORE
ASSEMBLY INSTRUCTIONS
Thank you for purchasing this quality product. Be sure check all packing material carefully for small parts
that may have come loose inside the carton during shipping.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the assistance
of one or more persons in order to prevent personal injury and to insure parts are not damaged during the
assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution applied on damp
cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for packaging
carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should
be periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or
cause injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.

Parts List:

A
B
C

Assembly Procedure:

Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware. Make sure the
quantity of each is correct.
Step 2: Assemble the metal plate (B) to the leg (C) using Hex Head bolt (2, flat washer (3). Tighten all bolts
securely with Allen key (1), but do not over tighten the bolts.
Step 3: Assemble the Table top (A) to the metal plate (B) using Hex Head bolt (1), flat washer (3). Tighten
all bolts securely with Allen key (1).
Assembly is now complete.
UNIVERSAL
™
H O M E
INSTRUCTION SHEET
1
1
2
(Please follow the sketches below.)
Page 1 of 2
U012750 HONOLUA DINING TABLE

Hardware List:

No
Description
1
Allen key M4
2
Hexagon Bolt M8x15
3 Washer M8x16x1.5
Figure
Q'TY
1
8
4