Advertisement
6.2. The priming phase may last from several seconds to a few minutes, dependant on conditions. Should this phase appear to be prolonged,
stop the pump and check the following:
That the pump is not running completely dry (see section 4.2 on priming the pump),
That the suction tubing is not allowing air in,
That the filter is not clogged,
That the difference in height between the pump and the end of the suction hose is not more than 2mtr,
That the delivery tube is allowing the evacuation of air.
6.3. When priming has occurred, ensure that the pump is operating as anticipated.
7.
MAINTENANCE
7.1. Check the pump casing, suction and delivery tubes regularly for leaks.
7.2. Keep the pump clean for easy detection of leaks.
7.3. Remove and clean the filter every 10 hours of operation or sooner if the transfer flow begins to decrease.
7.4. Dispose of environmentally hazardous parts in the proper manner.
7.5. This pump is protected from voltage surges and short circuits by a fuse. Should it become necessary to replace the fuse, ensure that the
correct rating is chosen and that the fuse is fitted correctly. If in doubt, contact your authorised Sealey dealer / service agent.
8.
DECLARATION OF CONFORMITY
Declaration of Conformity
Diesel/Fluid Transfer Pump
Models TP98 & TP9824
73.23/EECLow Voltage Directive
89/336/EECEMC Directive
93/68/EEC CE Marking Directive
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this equipment
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: Call us for a copy of our latest catalogue on 01284 757525 and leave your full name and address including your postcode.
01284 757500
We, the sole importer into the UK, declare that the products listed below are in conformity with the following EEC standards and directives
Signed by Mark Sweetman
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
01284 703534
The construction files for these products are held by the Manufacturer and may be inspected
on request by contacting Jack Sealey Ltd.
sales@sealey.co.uk
e-mail
15 August 2003
www.sealey.co.uk
Web
TP98 TP9824 - 4 - 081204
Advertisement
