Related Manuals for Thermomate GHSS915
Summary of Contents for Thermomate GHSS915
- Page 1 Built-in Gas Cooktop Live Smart, Better Life! GHSS915 Instruction / Installation Manual 1 (844) 334-4203 www.thermomate.com support@thermomate.com 3330-A Marathon Ct Charleston, SC 29418...
-
Page 3: Important Safety Instructions
– children climbing on the cooktop to reach items could be seriously injured. ● Proper installation – The cooktop, when installed, must conform with state or other codes or, in the absence of such codes, with the Standard for Recre ational Vehicles, ANSI/NFPA 1192. support@thermomate.com 3330-A Marathon Ct Charleston, SC 29418... -
Page 4: Installation
● These cooktops are designed to be dropped into counter top measuring >24 inches in depth. Please use the “Cutting size board”(cardboard packed in the box) to outline & cut hole in counter top. ● Minimum vertical clearances of 18″ from top surface unit to side cabinets. 1 (844) 334-4203 www.thermomate.com... - Page 5 TO FRONT SIDE OF ALLIANCE=1" MINIMUM VERTICAL CLEARANCES OF 18 INCHES FROM TOP SURFACE UNIT TO SIDE CABINETS Countertop Cutout Dimension Always consult the countertop manufacturer for specific installation instruc- tions or requirements. support@thermomate.com 3330-A Marathon Ct Charleston, SC 29418...
-
Page 6: Cooktop Installation
Model Cut Out Dimension(W X L) GHSS915 32.6″ x 18.5″ A cardboard with cut out hole size is packed in each box. Please use it to outline & cut hole in the counter top. Do not attempt to cut the hole before you received the unit &... -
Page 7: Connect The Cooktop To Gas
Never use an old connector when installing a new cooktop. GAS PRESSURE REGULATOR (SUPPLIED)ARROW TOWARD COOKTOP GAS SHUT OFF VALVE Fig. 5 support@thermomate.com 3330-A Marathon Ct Charleston, SC 29418... - Page 8 ● Please ensure to screw the top cover back on very tightly to well seal. Apply sealant when needed. NOTE: Conversion is operated on top cover assembly only. DO NOT adjust the regulator valve body to alter factory setting. 1 (844) 334-4203 www.thermomate.com...
-
Page 9: Start Up Test
Under all circumstances please have licensed plumber/technician to support the installation If you find an abnormality of the regulator valve, stop use it and contact thermomate. Do not attempt to modify this pressure regulator without consensus from thermomate. Start Up Test... -
Page 10: Electrical Connection
Ensure proper ground exists before use obligation of the customer to have it replaced with a properly grounded three-prong wall receptacle. Do not, under any circumstances, cut or remove the third(ground) prong from this power cord. 1 (844) 334-4203 www.thermomate.com... -
Page 11: Control Test
Gas flow to the burners is adjusted by turning the knobs which control the valves. Turning the knob so that the indicator line points to the symbols printed on the panel achieves the following functions: support@thermomate.com 3330-A Marathon Ct Charleston, SC 29418... - Page 12 ● To reduce the gas flow to minimum, rotate the knob further counter-clock- wise to point the o Lo Position. ● Other intermediate operating adjustments can be achieved by positioning the indicator between the HI and Lo positions, and never between the HI and OFF position. 1 (844) 334-4203 www.thermomate.com...
-
Page 13: Burner Ignition
Push and turn the knob for 1-2 seconds During a power failure, the burners will not light automatically. In an emergen- cy, a cooktop burner may be lit with a match by following the steps below: support@thermomate.com 3330-A Marathon Ct Charleston, SC 29418... - Page 14 HI position, try again with the knob in Lo position. ● To re-light the burner, return the knob to the OFF position and repeat the operation for light. ● To shut off burner, turn the knob in clockwise direction, to OFF position. 1 (844) 334-4203 www.thermomate.com...
- Page 15 Watch the flame, not the knob, as you reduce heat. The flame size on a gas burner should match the cookware you are using. Any flame larger than the bottom of the cookware is wasted and only serves to heat the handle. support@thermomate.com 3330-A Marathon Ct Charleston, SC 29418...
-
Page 16: Cleaning And Maintenance
Thermocouple are clean to ensure trouble-free sparking. Stainless steel can be stained if it’s in contact with highly calcareous water or aggressive detergents(containing phosphorous). It is recommended these parts be cleaned with water and then dried well. 1 (844) 334-4203 www.thermomate.com... -
Page 17: Troubleshooting
Check to make sure that: ● The gas holes are not clogged. ● There are no droughts near tire cooking surface. ● Tile minimum has been adjusted correctly(see the section entitled, “Mini- mum Regulation”). support@thermomate.com 3330-A Marathon Ct Charleston, SC 29418... - Page 18 The cookware is not stable. Check to make sure that: ● The bottom of the cookware is perfectly flat. ● The cookware is centered correctly on the burner or electric hot plate. ● The support grids have not been inverted. 1 (844) 334-4203 www.thermomate.com...
- Page 20 1 (844) 334-4203 www.thermomate.com support@thermomate.com 3330-A Marathon Ct Charleston, SC 29418...