CAUTION: Accessible parts may become hot when used with cooking appliance. Electrical shock hazard Only plug this unit into a properly earthed outlet. If you have doubts, seek advice from a suitably qualified engineer. 1(844) 334-4203 support@thermomate.com...
M6 X 50 M5 X 10 St4 X 6 5 X 30 X 16 X 16 Tools Required Pencil Measuring tape Hammer Screwdriver Electric drill or Level powered screwdriver INSTALLATION INSTRUCTIONS Prepare For Installation Ducted Option Recirculation Option 1(844) 334-4203 support@thermomate.com...
Page 6
Before installation, turn the unit off and unplug it from the outlet. 25.59-29.53 inch c. The range hood should be placed at a distance of 25.59-29.53 inch above the cooktop for the best effect. Note: No open flames directly approach to the range hood. 1(844) 334-4203 support@thermomate.com...
Diameter pipe: insert the damper as the picture and fix the converter before placing the duct. The pipe near the air outlet need to be fully extended. Drill 0.31 inch extra holes and fix screws & plastic wall anchors before installa- tion. 5.91inch 4.72inch 1(844) 334-4203 support@thermomate.com...
Fix the angle bars to the mounting plate, using the 8*M5×10 screws. Extend the angle bars to the required height and then fix them in position using the 16*M5×10 screws and nuts with metal washers. Important: The angle bars must have an overlap of AT LEAST 3.94 inch. 1(844) 334-4203 support@thermomate.com...
Page 9
Important: This stage of the installation process MUST be completed by two people. Important: The 16×M5x10 screws MUST be securely tightened. Remove the hanging hook and then slide the lower chimney section down- wards, until it rests against the main body of the range hood. 1(844) 334-4203 support@thermomate.com...
The working speed shows on this display screen. Power up key On working condition, press this key to increase the power one level. Light key Press one time for turning the lights on, press another to turn the lights off. 1(844) 334-4203 support@thermomate.com...
The Bulb may be hot,leave it 10 minutes before replacement. Aluminium and carbon filters replacement In order to install the carbon filter, the grease filter should be detached first. Press the lock and pull it downward. 1(844) 334-4203 support@thermomate.com...
Page 12
Repeat the same on the other side. 3 MONTHS Important Notice: 1. Make sure the filter is securely locked. Otherwise, it would loosen and cause abnormal noise and danger. 2. Using carbon filter would reduce the airflow of the range hood. 1(844) 334-4203 support@thermomate.com...
1. Open the alumunim/baffle filters, find the bracket on the oil cup lock on the motor cover. 2. Line up oil Cup. 3. Pull down. 4. Snap into place. 5. After the oil is filled, remove the oil cup, clean it and reinstall it for recycling. 1(844) 334-4203 support@thermomate.com...
25.59-29.53 inch. good EVIRONMENTAL PROTECTION Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. 1(844) 334-4203 support@thermomate.com...