Assembling An Array - Carvin Audio TRx Series User Manual

Assembling an Array

Assembly and deployment of TRx3210 arrays are carried out one array module at a time or in pre assembled
groups of array modules. With the SureFly™ hardware kit installed on each enclosure, attach the T-bar to the top
array enclosure. Each subsequent enclosure can be pinned at different angles to accomplish wide vertical coverage
angles and focus sound energy where needed.
Step 1
(skip with TRX3210 Flyware Model)
Installing the SureFlyTRx rigging kit on TRx3210NF.
Each TRx3210NF will require one SureFlyTRx rigging kit. The kit
includes all mounting hardware and quick release pins. Drilling into
the TRx3210NF enclosure is not required. All mounting points on
the TRx3210NF enclosure have threaded inserts.
Set all quick release pins aside. As shown in the diagrams, assemble
the side panels of the SureFlyTRx kit using the included bolts and
washers. Insert the adjustment plate in-between the two mounting
plates. The lower bolt will function as a hinge. Hand tighten the bolts
and insert the quick release pins as shown. Once the side plates are
aligned by installing the Quick Release Pins into the positions shown,
use a torque wrench to tighten the bolts to 20ft. lbs. Repeat this pro-
ceedure on the other side of the enclosure. After the SureFlyTRx
hardware has been installed on all enclosures, they may be stacked
4 high by making sure both side adjustment plates slide in-between
the mounting plates of the enclosure below. Store pins in the handle
area after installation.
Step 2
Installing the T-Bar
Attach assembled T-Bar to the top array enclosure. At
the same time lower side plates of the T-Bar even-
ly into the SureFly hardware. Attach the T-Bar side
plates using the bolts, washers and nuts supplied.
Using a torque wrench, tighten the bolts to 50ft lbs.
The T-bar side plates must insert between the two
plates of the array module hardware. Align holes and
secure with the included four (2 per side) quick re-
lease pins into both (A) and (B) holes.
T-Bar Side Plate
1.
Tighten bolts to 20 ft lbs
Washer
Adjustment
Plate
2.
1.
1.
2.
2.
Quick
1.
1.
Release Pins
2.
2.
1.
2.
1.
Tighten bolts to 50 ft lbs
T-Bar
Side Plate
1.
Mounting
Plate
2.
9