Installation - Equipex Sodir HOT-200 Operation Manual

The SODIR models HOT-200, HOT-300 and HOT-200L, HOT-300L low profile
countertop heated display cases are designed to offer quality holding and
merchandising of heated food. The displays are constructed of food service quality
stainless steel for commercial applications, and safety glass. The units are equipped
with a sheathed circular heating element, convection fan motor, regulating thermostat
and power switches for the light and heat. There is an internal display light in the
holding chamber, and 'L' models have a back-light front panel display. All models have
a removable water tray for humidity control. The units are thermostatically controlled up
o
to 200 F.
Specifications:
Model
Configuration
HOT Series
The SODIR heated display case needs to be connected to a grounded 120V outlet.
DO NOT place the unit in a damp area or near steam sources.
ventilation holes.
The SODIR display comes from the factory partially assembled. Prior to operation,
please remove the tie-wraps from the shelf, and install the rear doors by inserting
the top of one door, with the handle facing the outer edge, into the top inner track,
push it upwards and then lower it into the bottom inner track. Repeat with the
outside door placing it into the outer track.
protective film, which must be removed before operation. DO NOT operate the
display prior to removing the protective film completely. The unit should be cleaned
using a soft cloth dampened with a solution of soap and water, prior to first
operation. Be sure not to drip any water into the base, or ventilation cutouts.
INTRODUCTION
Electrical
120V, 1 PH, 1.5KW, 13A

INSTALLATION

ASSEMBLY
NEMA-5-15P
It is shipped with plastic exterior
Plug
Do not block