Table of Contents
Advertisement
SETTING UP YOUR TV
LNB allows you to determine the lower and higher
Local Oscillator Frequency (LOF). Usually, the
factory settings do not need to be changed. You
can find the parameters of the lower and higher
LOF on the specification sheet of your LNB.
Satellite Settings
Switch Type
LNB Power
No.
Satellite
1
Astra 19.2E
2
3
4
Transponder : 1/120 (10729) MHz
Dish Type : Fixed
Lower LOF : 9750
Upper LOF : 10600
Done
Press
B
/
b
to highlight Done and press OK.
x
If your satellite dish is moveable, the following
Positioning screen will appear.
Positioning
Satellite : ASTRA 23.5°E
Transponder
Go to 0
Go to Stored Position
Step Size
Positioning
Satellite : ASTRA 19.2°E
Signal Level
Quality
Store Position
Press
B
/
b
to highlight Positioning, and then
C
c
press
/
to find the dish position with the
strongest signal level.
B
b
Press
/
to highlight Store Position and press
OK to store the dish position. Repeat steps 23 and
24 for the next satellite as necessary.
Adjust the dish position manually for the maximum
Signal Level strength. The signal level strength is
displayed from 0 % to 100 %. A high signal level
can be achieved by adjusting the satellite dish the
best way possible.
Signal Level
B
b
Press
/
to highlight Done and press OK.
If your satellite dish is not movable, please adjust
the dish manually and press Done.
None
On
LNB
Dish
1
1
1/3(5MHz H(R))
1
W
E
0%
GOOD
30%
If you select Single Cable in step 23, the Single
Cable Settings screen will appear. You can set
the appropriate value for each item and highlight
Done.
Single Cable Settings
User Slot Number
User Slot Frequency
Password PIN
Verify Slot Frequency
y
If the reception testing completes successfully, the
Auto Tuning startup screen will display.
Auto Tuning - Satellite
Scan Type
Search Option
You can select Search Option from Free to Air or
All.
When choosing the search option All, all channels
(including encrypted ones) of the satellite will be
searched for. If you wish to only search for
unencrypted (free) channels, please select Free to
Air. In this case, the channel scan will be
completed faster.
z
b
Press
to highlight Start Scan, and press OK.
The television will start to search for available
DVB-S channels. The progress bar will indicate
the scan status.
When the search is complete, the Auto Tuning
results screen will display the total number of
services found.
Use
B
/
b
to move through the list to select a
channel, and then press OK to view.
PLEASE NOTE
The Quick Setup menu can also be accessed at
any time from the Installation menu.
20
0
1284
None
Done
Quick Scan
Free to Air
Start Scan
Advertisement
Table of Contents
