Axial Clearance A And Radial Clearance B; Fig. 27: Measuring Clearance A And B; Table 33: Permissible Clearances A And B - ABB HT588474 Operation Manual

Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
9 Dismantling and fitting / 9.8 Axial clearance A and radial clearance B
9.8

Axial clearance A and radial clearance B

Measure and record clearances A and B after the removal and before the installation of
u
the cartridge group.
Attach the dial indicator and align it for the respective clearance as per the illustration.
u
Fig. 27: Measuring clearance A and B
Product
TPS44
TPS48
TPS52
Table 33: Permissible clearances A and B
1. Move the rotor to and fro up to the stop. In order to obtain a correct measurement, elev-
ate the turbine a little.
2. Measure clearance A and compare it with the permissible values in the table.
3. Raise the compressor and push the turbine down at the same time.
4. Raise the turbine and push the compressor down at the same time.
5. Measure clearance B and compare it with the permissible values in the table.
CAUTION
Clearances outside the tolerance
Serious damage to engines or property can be caused by clearances outside
the tolerance and excessively worn parts.
Have the components assessed and, if necessary, replaced by an ABB Tur-
u
bocharging Service Station.
© Copyright 2017 ABB. All rights reserved.
A [mm]
0.10 ... 0.18
0.11 ... 0.19
0.13 ... 0.22
HZTL4037_EN
B [mm]
0.69 ... 1.27
0.86 ... 1.52
0.98 ... 1.68
Revision E July 2017