Table of Contents
Advertisement
Fault
The programme duration
changes during the wash
cycle.
No water is visible in the
drum.
Drum jerks after the pro-
gramme starts.
Residual water is present in
the compartment
Vibrations and movement of
the appliance whilst spin-
ning.
Drum does not turn, water
does not flow in.
Heavy foam build-up
High spin speed not
reached.
Cause
The programme operation is
optimised electronically.
This may change the pro-
gramme duration.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
Water is below the visible
area.
This is caused by an internal
motor test.
Insert in compartment
.
blocked.
Appliance is not correctly
aligned.
The appliance feet are not
fixed.
Transit bolts have not been
removed.
Load detection is active.
Detergent dosage is too
high.
A low spin speed is selected.
Troubleshooting
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Do not add any extra water to the
▶
appliance while it is operating.
Not a fault – no action required.
▶
→ "Cleaning the detergent drawer",
is
▶
Page 37
Aligning the appliance
▶
Secure the appliance feet. Aligning
▶
the appliance
Removing the transit bolts
▶
Not a fault – no action required.
▶
Note: The load detection can take up
to two minutes.
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the left-hand compartment (not
for outdoor clothing, sportswear or
items stuffed with down).
Reduce the amount of detergent for
▶
the next washing cycle with the
same load.
The next time you run a wash cycle,
▶
set a higher spin speed.
Troubleshooting en
47
Advertisement
Table of Contents
