Table of Contents
Advertisement
Available languages
Available languages
Tools:
• Pipe tape
• Adjustable wrench
• Plumber's putty
• Groove joint plier
• Phillips screwdriver
• Hex wrench
Safety Tips
• If you solder during faucet installation, remove cartridges,
seats and washers prior to applying flame, otherwise you
will void the warranty.
• Cover drain openings to avoid loosing parts.
• When cutting or soldering pipe, use safety glasses to
protect your eyes.
Things You May Need
All installations can vary depending on how your previous faucet was installed. Necessary supplies to install your faucet are
not all included; however they are available wherever plumbing supplies are sold. When choosing your installation supplies,
make sure they are IAPMO and/or CSA approved products.
Need help?
For additional assistance or service call:
1 888 328-2383 USA
What you need to know
Maintenance
Your new bathroom faucet is designed for years of trouble-free
performance.
Keep it looking new by cleaning it periodically with a soft cloth.
Avoid abrasive cleaners, steel wool and harsh chemicals as these
will dull the finish and void your warranty.
Important Points
Prior to beginning installation, turn off the cold and hot water lines
and open the old faucet to release build-up pressure.
Prior to new faucet Installation, turn the connector nuts finger-tight,
then use one wrench to anchor the fitting and a second wrench to
tighten the nut one additional turn. Connections that are too tight
will reduce the integrity of the system.
Wrap all threaded connections with pipe tape available at your local
plumbing supply store. Always wrap in a clockwise direction. The
fittings should be installed by a State-licensed plumber.
Advertisement
Table of Contents
