Universal Explore Home PARADOX 827636-RTA Instruction Sheet

827636-RTA
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.

PARTS LIST:

# Description
A Chair
C Back Leg

Assembly Procedure:

CAUTION: PLEASE DO NOT OVER-TIGHTEN BOLTS DURING ASSEMBLY.
NOTE: FIRST READ THE CHAIR LEVELING INSTRUCTIONS. THIS IS AN ADDITIONAL
ASSEMBLY INSTRUCTION SHEET FOUND INSIDE THE CARTON.
Step 1: Place all chair parts on a soft and smooth surface. Take out the wooden legs and the
package of hardware accessories under the chair seat
Step 2: Attach the back corner blocks of Chair (A) to Back Leg (C) using Bolt (1), Spring Washer
and Flat Washer.Tighten with Allen Key (2) .
Step 3: Attach the front corner blocks of Chair (A) to Front Leg (B) using Bolt (1), Spring Washer
and Flat Washer. Tighten with Allen Key (2).
Step 4: After making sure all bolts are attached and tightened, turn the chair over.
Step 5: Level the chair following "Chair Leveling Instruction". This is an additional assembly
instruction sheet found inside the carton.
Step 6: Make sure the chair is level and tighten all bolts completely using the Allen Key supplied.
Assembly is now complete.
1
NO
2
For
Side Chair
INSTRUCTION SHEET
Qty. #
1 pc B
2 pcs
Hardware
2-1/6" L
Bolt+Spring Washer+Flat Washer -- 5/16" Dia
Allen Key
PARADOX DINING CHAIR
Description
Front Leg
List
Qty.
2 pcs
Qty.
8pcs
1pc