Maintenance - abi SR2 COMMAND Series User Manual

Using the SR2 Finish Rake –
The Finish Rake on the SR2 can be used as a independent feature for use on jobs to distribute loose material. To
use the finish rake as an independent feature follow the following procedure:
Smoothing out material with the Finish Rake:
1. With the SR2 attached to the Skid Steer, transport the SR2 to an area where the material has been broken up
using the scarifiers on the SR2.
2. Lift the SR2 using the boom, and tilt the SR2 so that the finish rake is angled below the wheels of the SR2.
3. Lower the SR2 down so that the finish rake rest firmly on the surface. For areas with uneven surfaces the
boom may need to be lowered or raised to prevent excess material from building up, or to allow for material
to continue to be moved.
4. Slowly back up with the Skid Steer allowing the finish rake to move the material.
5. To give the job a finished look slowly raise the boom as the Skid Steer moves backward to allow the material
to feather out over an area.
Pushing Material with the Finish Rake:
**Note to Operator: The SR2 can be used to push material into an area. Always ensure the material has been
loosened prior to pushing material, and never push material into an area where obstacles may be hidden, or out of
operator view to prevent damage to the SR2 or property.
1. With the SR2 attached to the Skid Steer, transport the SR2 to an area where the material has been broken up
using the scarifiers on the SR2.
2. Lift the SR2 using the boom, and tilt the SR2 so that the finish rake is angled below the wheels of the SR2.
3. Lower the SR2 down so that the finish rake rests firmly on the surface of the material.
4. Slowly push forward allowing the material to move forward with the SR2.
5. Once the material is moved into the area where it is needed, raise the boom and tilt the SR2 forward to allow
the excess material to be deposited into the area.
Maintenance –

Check hardware daily to ensure that nuts and bolts are tight, and that pins are properly secured. If any
hardware is found to be damaged replace hardware prior to operating the SR2

The hubs will need to be repacked every 6 months. ABI recommends using a Hi-Temp Grease for packing the
bearings inside the hubs.

With the Hydraulic Scarifier Option: Check hydraulic fluid levels daily.

With the Hydraulic Scarifier Option: Check all hydraulic hoses daily for damage or leaks. Replace any
damaged hoses prior to operating the SR2.
Please read fully and understand before operating!!
Page 8 of 9