Waste Disposal; Electrical Connections - Bompani CR904/R Instruction Manual

GB
WARNINGS
- Read the instructions carefully before using your new
appliance. They contain information that is important
for your safety and also for proper maintenance of the
appliance.
- This suction hood complies with safety regulations.
- Repairs must only be carried out by authorised technicians.
- The appliance must not be used by persons (including children)
with limited physical, sensorial or mental abilities, or without the
necessary experience or knowledge, unless they are supervised
by a person responsible for their safety or have been instructed
by that person regarding the use of the appliance.
- The suction hood can be used in extraction mode and in fi ltration
mode.
- The suction hood must always be fi tted so that it is centred over
the cooker hob.
- If the installation instructions for the gas cooker indicate that a
distance of more than 65 cm must be left between the hob and the
lower edge of the suction hood, it is essential that this be complied
with.
- Over solid fuel stoves in which there is a risk of fi re (e.g. from
sparks) the suction hood is only allowed if the stove is fi tted with a
non-removable closed cover and if the relevant national regulations
are also met.
- This restriction does not apply to gas hobs and gas cookers.
- Never use the suction hood without a fi lter.
WARNINGS FOR GAS COOKERS
- When fi tting gas hobs, do not use all the burners
simultaneously at maximum power for long periods
(max. 15 minutes), otherwise there is a risk of
burning if the surface of the casing is touched or a
risk of damage to the suction hood.
- When using the suction hood over a gas hob, the suction hood
must be set to maximum suction power if three or more burners
are being used.
- For gas hobs, the minimum distance between the upper edge
of the pan support grill and the lower edge of the suction hood
is 650 mm.

WASTE DISPOSAL

- This directive provides the regulations for collec-
tion and recycling of decommissioned appliances
that apply throughout the European Union.
- This appliance is marked in accordance with European Directive
2002/96/EC on waste electrical and electronic equipment –
WEEE.

ELECTRICAL CONNECTIONS

For direct connection to the mains it is necessary to provide a cut-out
device with a contact aperture that allows for complete disconnection in
the case of category III power surges, in compliance with the installation
regulations.
The power plug must be accessible after installation.
WARNING! If the power cable is damaged, please contact
the manufacturer or an authorised technician to replace
it. The hood complies with EEC regulations on screening
against radio frequency disturbance.
WARNING! If the Touch-Screen sensitivity is low, reverse
the polarity of the power supply (turn the plug around or
reverse the positions of the BLUE-BROWN cables in the
mains connection terminal board).
Fig 1
X
x 6
Y
x 6
Z
x 2
DESCRIPTION OF KIT
A
Suction hood
B
Wall bracket
C
Chimney extension
D
Chimney
Fig 2
FITTING THE SUCTION HOOD
To fi t the suction hood properly to the wall, proceed as follows:
1 Position bracket A on the wall, drilling the 4 holes required, then fi x
it using the screws X and wall plugs Y provided (fi g.2).
Fig 3
X
2 Position the hood, hooking it to bracket A installed as described
above, then adjust centring over the hob an fi nally fasten using
screws X (fi g.3).
A+A02
E
D
C
B
A
E
Chimney bracket
X
Wall screw
Y
Wall plug
Z
Chimney screw
A
B
A
5