1 - EQUIPMENT SUPPLIED Description Control Screw+wall plug Installation instructions 2 - INSTALLATION 2.1 - Wall-mounted control IMPORTANT: ● D o not position the control on parts of the wall covering pipes or electrical cables. It is recommended to position it Allconnectionsmadebetweentheunitandthecontrolmustbe approximately150cmfromtheground.
3 - CONTROL T hecontrolisusedin2-tubesystemswithheating,2-tubesystemswithcoolingand2-tubesystemswithheating/cooling. 3.5 - Summer/winter switching HEE control Fig.5 ● M anual Heating/cooling mode is selected manually by pushing the controlbutton(no.5) ● N ightmode Iftheuserdoesnottouchthekeysorthebuttonfor10seconds, theLEDsaredimmed. 3.6 - Use Buttonfunctions: ● P OWER Thisbuttonisusedtoswitchthecontrolunitonandoff.Once theunitisoff,allthefunctionsaredeactivated,howeverthe controlsystemisstillsuppliedwith230V.Ifthefrostprotection functionisselectedusingthecorrespondingmicroswitch,this ON/OFFkey BlueLED–coolingmode...
3 - CONTROL (continued) 3.11 - Using the temperature sensor Fig.6 ● I ndoorsensor: Used in all installations with a wall-mounted control unit. JumperJP1isclosedasshowninfigureAandprintedonthe electronic board. Note: in the factory configuration, the active sensor is the indoor sensor Fig.A Indoor sensor 3.9 - "Shunts"...
Need help?
Do you have a question about the HELIOTHERME 3V HEE and is the answer not in the manual?
Questions and answers