Table of Contents
Advertisement
Operator Instruction Guide
1.
It is important that this manual is read and fully understood and that all instructions are
followed before using the beam clamp.
2.
The beam clamp should be used by a trained and or experienced person who understands its
use and will operate the unit in a responsible and safe manner.
3.
Inspect the beam clamp for any damage or wear before use. Do not use the beam clamp if it
is not in good working order. Continuous monitoring of the condition of the machine is an
important safety consideration.
4.
The supplier takes no responsibility for any consequential loss or damage if the beam clamp
has been dismantled or altered by an unauthorised person, especially if original parts were
not used to repair the machine.
5.
The clamps described in this manual must not be used to lift, support or transport people in
any way.
6.
These clamps are for manual operation only. Do not attempt to use a motorized mechanical
device to operate the machine.
7.
Check the beam clamp is of the correct profile, size and lifting capacity, or correctly adjusted,
for the beam width and that it seats correctly on the beam flange.
8.
Ensure the supporting structure is adequate for the full load that will be imposed and suitable
for the application.
9.
The adjusting screw must be fully hand tight before any load is applied; failure to do so could
result in serious injury to persons or damage to equipment.
10. Do not attempt to overload the machine as this could cause damage to person or equipment.
11. Always ensure the beam clamp is used, maintained and repaired by a competently trained
person.
12. Do not use the beam clamp in explosive environments unless an ATEX version has been
supplied.
Contents:
1.
2.
3.
4.
and Disposal
5.
For details of the full Tiger product range visit our website: www.tigerlifting.com
Due to our policy of continual product development, dimensions, weights and specifications may change without prior
notice.
© Copyright Tiger Lifting UK Limited. No part of this manual shall be reproduced, transmitted, transcribed, translated into
any language human or electronic, stored in any electronic retrieval system, in any form without the written permission of
Tiger Lifting UK Limited, Alnwick, UK
Unit 1, Greensfield Industrial Estate,
Willowburn Avenue,
ALNWICK, NE66 2DG
Email: info@tigerlifting.com
MUST READ BEFORE USE
2
6.
3
7.
4
8.
5
9.
5
www.tigerlifting.com
www.tigerlifting.com
Page 1 of 14
Manual BCF En 201706 v2.0
6
7
9
13
Advertisement
Table of Contents
