Summary of Contents for Vantage Hearth GAL KIT00-1001N
- Page 1 GAL Universal Operator and Header Mounting Kits Designed for All GAL Operators and Car Door Headers Installation Guide Rev A...
- Page 2 GAL UNIVERSAL MOUNTING KIT (intentionally left blank)
-
Page 3: Table Of Contents
GAL UNIVERSAL MOUNTING KIT Contents Contents ....................... 1 Introduction ....................1 General Installation and Setup ..............2 2.1. Preliminary Steps ................2 2.2. Header Mounting ................2 2.3. Operator Support Mounting .............. 4 1. Introduction This kit is designed to allow for easy installation of GAL headers and operators to the transom and cartop during modernization. -
Page 4: General Installation And Setup
GAL UNIVERSAL MOUNTING KIT 2. General Installation and Setup 2.1. Preliminary Steps • Remove the car from service, in compliance with standard safety policies. Position the cab so the doors and header are accessible from the hoistway. • • Unhang the cab doors and remove all existing door equipment including hangers, tracks, header, and operator. - Page 5 GAL UNIVERSAL MOUNTING KIT KIT00-1001N is designed to be able to mount GAL headers of any length. 5/16-18 holes are spaced 10” apart for the GAL haeder to be attached. Slots are cut periodicly down the length of the bracket to allow for it to be cut down in the field easily if needed.
-
Page 6: Operator Support Mounting
GAL UNIVERSAL MOUNTING KIT 2.3. Operator Support Mounting The operator supports mounting kit P/N: KIT00-0102N consists of two identical “L” brackets to support the operator. There are two different mounting configurations designed to support the back of the operator regardless of the distance from the top of the car top to the bottom of the operator. - Page 7 GAL UNIVERSAL MOUNTING KIT 2.3.2. Kit Assembly • Place the one angle P/N: KIT00-1002N so that: The flange with tapped holes is flush to the car top. The tapped holes are in line with the motor base plate slot (about 2” from the edge of the header) The vertical flange is at least 1 ½”...
- Page 8 GAL UNIVERSAL MOUNTING KIT For Config. A, the top angle will have the flange with tapped holes upright and flush with the upright bottom flange. For Config. B, the top angle will have the flange with tapped holes facing downward and flush with the upright bottom flange.