iLight Verre Series Installation Manual

Installation guide
Verre - Capacitive Glass Control Plate

Introduction

Verre Series from iLight provide an elegant and
flexible solution for the control of lighting, shading
and HVAC systems.
These control plates are connected to the iCAN
network using a removable connector on the rear
of the panel.

Fixing to a wallbox

Verre Control Plates fit into a standard single gang
47mm deep UK backbox.
(Backboxes available from iLight)
Using the 2 screws provided, attach the control
plate to the back box.
Front Face Plate
Screws x 2
Backbox (Order separately)
Fixing tabs
Control Plate

Fixing the front cover

Once the control plate is installed in the
backbox, the front cover can be attached.
There are fixing clips on the top and bottom
of the control plate. The front cover should
be sat over the top fixing clips and then
pressed over the bottom clips to secure it into
position.

Removing the front cover

To remove the cover, there is a channel on
the underside of the assembly. Using a small
screwdriver, insert the end into this channel
and carefully pry the cover towards you.
Once the clip is disengaged the cover can be
removed.
Clips
Clips