Trane CGAM020 Installation Instructions Manual page 15

Table 18. Kit contents LVR01100
# Qty Per Component Part Component Description
1 4 572095370100
2 16 X25030266010
3 2 572095360100
4 127 X25020604010
5 12 572055590100
6 1 572116120100
7 1 572094890100
8 2 572055570100
9 1 572116160100
10 1 572116130100
12 1 572116030100
13 1 572116070100
14 1 572116080100
15 2 572116100100
Figure 9. CGAM040–052 ton (V1 units); 1 of 2
Figure 10. CGAM040–052 ton (V1 units); 2 of 2
PART-SVN228B-EN
PANEL; LOUVER
SCREW; M6 X 16MM HEX CAP
SUPPORT; LOUVER
SCREW;M8 X 1.25MM X 16MM
LOUVER; UNIT SIDE CGAM
SUPPORT; LOUVER
POST; LOUVER
LOUVER; LOWER END CGAM
PANEL; TOP CONTROL PANEL
SUPPORT; PANEL
PANEL; UNIT END
PANEL; UNIT END
PANEL; BPHE INLET/OUTLET
PANEL; PHR INLET/OUTLET
1. Install four side louver supports
Item 1), two on each side of unit, with provided
M6 X 16 screws (Figure
2. Install center louver supports
each side of unit with provided M8 X 16 screws
(Figure 11, Item 4).
Note: Do not use an impact gun when installing
plastic louvers.
3. Install six upper louvers
side, with provided M8 X 16 screws
4. Install lower end louver support
with provided M8 X 16 screws
5. Install lower end louver post
provided M8 X 16 screws
6. Install lower end louvers
provided M8 X 16 screws
7. Install top control panel strip
provided M8 X 16 screws
8. Install lower support (Figure
with provided M8 X 16 screws
Note: Installation of Item 11 in
on units that do NOT have heat recovery option.
9. Install center rear end support panel
Item 11) with provided M8 X 16 screws
Item 4).
10. Install the three lower unit end panels
Item 12, Item 13, and Item 14) with provided M8 X 16
screws (Figure 11, Item 4).
11. Install upper unit end panels
Item 16) with provided M8 X 16 screws
Item 4).
12. Install six lower louvers
side, with provided M8 X 16 screws
Installation
(Figure 11, p. 16,
11, Item 2).
(Figure 11, Item 3) to
(Figure 11, Item 5), three each
(Figure 11, Item 4).
(Figure 11, Item 6)
(Figure 11, Item 4).
(Figure 11, Item 7) with
(Figure 11, Item 4).
(Figure 11, Item 8) with
(Figure 11, Item 4).
(Figure 11, Item 9) with
(Figure 11, Item 4).
11, Item 10) on end of unit
(Figure 11, Item 4).
Step 9 is only required
(Figure 11,
(Figure 11,
(Figure 11,
(Figure 11, Item 15 and
(Figure 11,
(Figure 11, Item 5), three each
(Figure 11, Item 4).
15