Related Manuals for Eurotek Elite Series
Summary of Contents for Eurotek Elite Series
- Page 1 TECHNOLOGY FOR THE MIND NeuroTek Elite Series Wireless Pulsers Quickstart Guide Important: Please read all instructions completely before operating this device ©NeuroTek 2021 ©NeuroTek 2020...
- Page 2 Liability Disclaimer This product is a tool designed to assist the clinician in the administration of (EMDR). The purchaser/clinician agrees to accept full responsibility for any harmful results and/or undesirable consequences obtained from the use of this machine. The manufacturer of this machine shall not be held liable for adverse affects caused to clients resulting from the administration of EMDR or any other form of therapy using this machine.
- Page 3 Product Features Pulsers and Base Package Contents Package Contents Adapter Pulsers and Base Adapter Pulsers and Base Package Contents Adapter ©NeuroTek 2020 ©NeuroTek 2020 Adapter Pulsers and Base ©NeuroTek 2020 ©NeuroTek 2021...
- Page 4 Wireless Pulsers Quickstart Guide Wireless Pulsers Quickstart Guide Wireless Pulsers Quickstart Guide The Wireless Pulsers can be used with the Advanced and De- The Wireless Pulsers can be used with the Advanced and De- luxe Tacs. The Charging Base can also power other devices. luxe Tacs.
- Page 5 ➌ Wireless Pulsers Connection ✓ ✓ Manually select Manually select the Wireless pulsers each pulser. Press devices to pair and show up as left and remove or connect. press connect. right and both must be selected. Press connect to pair. ©NeuroTek 2021 ©NeuroTek 2020...
-
Page 6: Troubleshooting Guide
Troubleshooting Guide Issue Solution Charging is shown by the LED on the Normal Pulser charging charger dock below the Pulser. Flashing = not connected to Pulser Solid red= charging Solid green=full charge Pulser LED continues to flash Check that Pulser is seated into the dock when Pulser is on the dock and makes contact with the spring pins. -
Page 7: Troubleshooting
Troubleshooting Issue Solution Connection dropped with The Tac distance to the Pulser should not be one or both Pulser during a more than 15 feet. Try moving closer and session reconnect the Pulser. Make sure the patient is not covering the LED area of the Pulser with their hands, as this blocks the antenna. - Page 8 Troubleshooting Issue Solution One pulser continues to run Press play and then pause again to reestablish after pause is pressed during the synchronization of the Pulser. a session PLAY ©NeuroTek 2021 Version 2.0...
-
Page 9: Package Contents
Troubleshooting Package Contents Issue Solution Cannot charge peripheral Verify that the adapter used is rated at 2.1A Pulsers and Base device (phone) with the on the label. charger dock Pulser and Base Adapter socket Adapter Adapter ©NeuroTek 2021 Version 2.0... - Page 10 charge other devices Plug adapter into Troubleshooting the Pulser base If the pulser is frozen and won’t turn off, please use a small paper clip and insert it into the small hole on the inside of the pulser near the tip. You will feel the button click and this ➋...
- Page 12 11435 Challenger Ave Odessa, FL 33556 727-372-0104 www.neurotekcorp.com ©NeuroTek 2021...
Need help?
Do you have a question about the Elite Series and is the answer not in the manual?
Questions and answers